Dropbear ssh dd-wrt
![dropbear ssh dd-wrt dropbear ssh dd-wrt](https://kcore.org/assets/images/2006/06/ddwrt1.jpg)
![dropbear ssh dd-wrt dropbear ssh dd-wrt](https://arachnoid.com/android/SSHelper/resources/SSHelper_display_large.png)
TP-LINK TD-8817 ADSL2+ Modem Router, configured as bridge, web page at 192.168.1.1.ADSL2+ service with static IP (no PPPoE or DHCP).If you wish to enter it manually, you should run echo `nvram get wan_ifname` to get your WAN interface name. `nvram get wan_ifname` gets the WAN port of your router automatically.
DROPBEAR SSH DD WRT CODE
On builds newer than 42755 you may need to change the above code and enter both lines under the firewall settings instead of splitting them: ifconfig `nvram get wan_ifname`:0 10.0.0.2 netmask 255.255.255.0 Iptables -t nat -I POSTROUTING -o `nvram get wan_ifname` -j MASQUERADE Replace the 10.0.0.2 with an IP in the same range as the modem. NOTE: For all methods below, you may need to substitute $(nvram get wan_ifname) for `nvram get wan_ifname)` if `nvram get wan_ifname)` does not work. You need to either set the modem to use a different subnet or set the router's LAN to use an IP in a different subnet such as 192.168.2.1 so that they're not using the same subnet.īy default if you type the IP address of the modem you have an "Impossible to contact the server" error. This is the same subnet that DD-WRT uses for the LAN by default. Note: Many modems come configured to use the 192.168.1.x subnet. The default gateway is the Modem address and the Card address is the one provided by the modem. The easiest way to know these addresses is to connect the modem directly to your computer and take a look at your network card configuration. My modem is a Speedtouch 510, is IP address is 10.0.0.138 and it gives the 10.0.0.1 address to the device connected to it. Usually the modem gives an address to the client but this address will never be used except to access the configuration interface of the modem. In this case the router itself creates the PPPoE connection to the ISP server but to work, the connection between the modem and the router must have an IP address.